[HP OO] Using QC (178 Views)
Reply
Occasional Advisor
Posts: 20
Registered: ‎10-30-2013
Message 1 of 1 (178 Views)

[HP OO] Using QC

Hi all,

 

I can technical access QC via OO-Flows using the prefdefined flows under /Library/Hewlett-Packard/Application Lifecycle Management .

Now I got caught at the following point:

How will I get tests out of QC via OO, which flows I have to use. My preferred inputs will be an application name, a release number and probably a change. Will this be sufficient?

Are there any documents describing how to get tests out of QC via OO?

I already got the document attached, but it only describes how to connect and which flows are available, not which I have to use in which order.

 

Thanks a lot!

 

Regards, Till

The opinions expressed above are the personal opinions of the authors, not of HP. By using this site, you accept the Terms of Use and Rules of Participation.