P800 controller problem (1953 Views)
Reply
Occasional Contributor
Dmitryk6
Posts: 4
Registered: ‎11-23-2009
Message 1 of 4 (1,953 Views)

P800 controller problem

Hello. I have a P800 controll with MSA-70 connected. And very often server "looses" the MSA-70 and users can't get access to they documents. At this time I can see following errors:

Source: Cissesrv
Event ID: 24584
Description: Too many runtime ECC errors have been received from the array controller P800 located in server slot 2. The controller has restarted without utilizing its DIMM.

Source: HpCISSs2
Event ID: 11
The driver detected a controller error on \Device\RaidPort0.

And then I can see a lot of system warning "An error was detected on device \Device\Harddisk1 during a paging operation."

ACU says that Controller Status is "ATTR_VALUE_CONTROLLER_STATE_CACHE_PROBLEM",
Cache Status: Permanently Disabled
Cache Status Details: A cache error was detected. Run a diagnostic report for more information.


It all that I can see. And the most exciting question is: this is a controller issue or it's a problem with MSA?
Please use plain text.
Acclaimed Contributor
Torsten.
Posts: 23,216
Registered: ‎10-02-2001
Message 2 of 4 (1,953 Views)

Re: P800 controller problem

The DIMM on the controller may be bad.

Hope this helps!
Regards
Torsten.

__________________________________________________

There are only 10 types of people in the world -
those who understand binary, and those who don't.

__________________________________________________

No support by private messages. Please ask the forum!

If you feel this was helpful please click the KUDOS! star in the left column!   
Please use plain text.
Honored Contributor
Víctor Cespón
Posts: 2,397
Registered: ‎11-09-2007
Message 3 of 4 (1,953 Views)

Re: P800 controller problem

Cache Status: Permanently Disabled

Because there has been ECC errors on the controller cache.
Request the DIMM to be replaced.
Please use plain text.
Occasional Contributor
Dmitryk6
Posts: 4
Registered: ‎11-23-2009
Message 4 of 4 (1,953 Views)

Re: P800 controller problem

Yes, it's a P800 cache problem. After replacing - it seems to be working fine.
Please use plain text.
The opinions expressed above are the personal opinions of the authors, not of HP. By using this site, you accept the Terms of Use and Rules of Participation