Re: how to check if we had install the BBWC in linux? (1701 Views)
Reply
Occasional Contributor
Romeo Lou
Posts: 7
Registered: ‎03-29-2010
Message 1 of 2 (1,701 Views)

how to check if we had install the BBWC in linux?

Dear all,
I use following command to check,

cd /opt/compaq/hpacucli/bld/
./hpacucli

ctrl all show status

ctrl slot=? show

But, what's the keyword in output for BBWC?
please ref attached file.


Please use plain text.
Honored Contributor
kris rombauts
Posts: 1,175
Registered: ‎03-26-2002
Message 2 of 2 (1,701 Views)

Re: how to check if we had install the BBWC in linux?

Hi Romeo,

looks like you don't have the BBWC, look at this output. Your Battery pack count = 0.
Don't think there is a separate option/keyword to ACU CLI just retrieve that piece if information only.


HTH

Kris


=> ctrl slot=0 show

Smart Array P400 in Slot 0 (Embedded)
Bus Interface: PCI
Slot: 0
Cache Serial Number: PA82C0J9SWB3VJ
RAID 6 (ADG) Status: Enabled
Controller Status: OK
Chassis Slot:
Hardware Revision: Rev E
Firmware Version: 5.26
Rebuild Priority: Medium
Expand Priority: Medium
Surface Scan Delay: 15 secs
Post Prompt Timeout: 0 secs
Cache Board Present: True
Cache Status: OK
Accelerator Ratio: 25% Read / 75% Write
Drive Write Cache: Disabled
Total Cache Size: 256 MB
No-Battery Write Cache: Disabled
Cache Backup Power Source: Batteries
Battery/Capacitor Count: 1
Battery/Capacitor Status: OK
SATA NCQ Supported: True

Please use plain text.
The opinions expressed above are the personal opinions of the authors, not of HP. By using this site, you accept the Terms of Use and Rules of Participation