how to check if we had install the BBWC in linux? (1903 Views)
Reply
Occasional Contributor
Romeo Lou
Posts: 7
Registered: ‎03-29-2010
Message 1 of 2 (1,903 Views)

how to check if we had install the BBWC in linux?

Dear all,
I use following command to check,

cd /opt/compaq/hpacucli/bld/
./hpacucli

ctrl all show status

ctrl slot=? show

But, what's the keyword in output for BBWC?
please ref attached file.


Honored Contributor
kris rombauts
Posts: 1,175
Registered: ‎03-26-2002
Message 2 of 2 (1,903 Views)

Re: how to check if we had install the BBWC in linux?

Hi Romeo,

looks like you don't have the BBWC, look at this output. Your Battery pack count = 0.
Don't think there is a separate option/keyword to ACU CLI just retrieve that piece if information only.


HTH

Kris


=> ctrl slot=0 show

Smart Array P400 in Slot 0 (Embedded)
Bus Interface: PCI
Slot: 0
Cache Serial Number: PA82C0J9SWB3VJ
RAID 6 (ADG) Status: Enabled
Controller Status: OK
Chassis Slot:
Hardware Revision: Rev E
Firmware Version: 5.26
Rebuild Priority: Medium
Expand Priority: Medium
Surface Scan Delay: 15 secs
Post Prompt Timeout: 0 secs
Cache Board Present: True
Cache Status: OK
Accelerator Ratio: 25% Read / 75% Write
Drive Write Cache: Disabled
Total Cache Size: 256 MB
No-Battery Write Cache: Disabled
Cache Backup Power Source: Batteries
Battery/Capacitor Count: 1
Battery/Capacitor Status: OK
SATA NCQ Supported: True

The opinions expressed above are the personal opinions of the authors, not of HP. By using this site, you accept the Terms of Use and Rules of Participation.