Re: HP Network Configuration Utility (NCU) (2462 Views)
Occasional Visitor
Posts: 1
Registered: ‎08-21-2008
Message 1 of 2 (4,033 Views)

HP Network Configuration Utility (NCU)

[ Edited ]

I have made Fault tolerant network card by HP Network Configuration Utility (NCU)on PROLIANT DL380 G3 server using two HP NC7781 Network cards.
I try to update the drivers of Network card and NCU-- (NIC from to and NCU from to
first i started NCU but it gave error update miniport drivers first so i start updating NIC drivers it was ok but i lost network connectivity the through KVM i updated the NCU drivers it was also ok without error.

After reboot nothing worked all network cards disabled and not possible to enable -- when trying to enable gives no error message but not getting enabled.

no roll back possible for NIC total disaster trying to run NCU it gives error for XML file i dissolve the Teaming and run NIC in simple mode.

Can any one help me how to recover from this and what could be the possible cause of this all OS was Win2003 server.



P.S. This thread has been moved from ProLiant Servers - Netservers to ProLiant Servers (ML,DL,SL). -HP Forum Moderator

Occasional Visitor
Posts: 1
Registered: ‎01-01-2014
Message 2 of 2 (2,462 Views)

Re: HP Network Configuration Utility (NCU)

me too

The opinions expressed above are the personal opinions of the authors, not of HP. By using this site, you accept the Terms of Use and Rules of Participation.