HP ML110 G4 Embedded RAID gone haywire (90 Views)
Reply
Occasional Contributor
tpanicos
Posts: 2
Registered: ‎02-13-2013
Message 1 of 1 (90 Views)

HP ML110 G4 Embedded RAID gone haywire

[ Edited ]

Hi,

 

Wondering if there is anyone that can point me out in the right direction.

 

I have a HP ML110 G4 and I am using the Embedded SATA RAID Controller and currently have to Arrays configured.

 

1. RAID 0 - 2 x 250Gb

2. RAID 0 2 x 750Gb

 

Last night we had a power cut for a good few hours and when I tried this morning to turn it on, during boot, the drives are all detected and are 'Healthy' but the Arrays are coming up as Failed.

 

When I go into the Array Config Utility and choose either of the arrays, again, the array members are detected correctly but I noticed that one of the array members (in both seperate arrays) is in grey font and the other is white.

 

Can anyone please help point me in the direction as of what to do to get my system up and running again?

 

Thanks

Please use plain text.
The opinions expressed above are the personal opinions of the authors, not of HP. By using this site, you accept the Terms of Use and Rules of Participation