01-03-2014 03:02 AM - last edited on 01-05-2014 07:18 PM by Lisa198503
So I am completley new to Vlan and diving in at the deep end here.
I want to setup 2 Vlans on my 2626
At the moment I am going to leave the deafult vlan as my first and add in the second which will be for BYOD network.
For testing I will be using only the 1 switch (2626)
Port 1 conected to the Windows 2003 DHCP server
Port 2 connected to BYOD device (laptop)
Port 3 Desktop PC
Currently I have 2 scopes set up on server
I want devices in port 2 to obtain a 168.192 address and all other ports a 20.192 address.
So far on the switch I have -
Enabled DHCP relay
set manual IP for both vlans
on default ports 1 & 3-24 untagged
on Vlan 20 port 2 untagged
I think I am going very wrong somewhere as this is simply not working and have tried a variety of things which has not worked. Any help would be very much appreciated.
P.S. This thread has been moved from Switches, Hubs, Modems (Legacy ITRC forum) to ProCurve / ProVision-Based. -HP Forum Moderator
01-03-2014 03:38 AM
Quick note: all addresses have been changed from the real addresses.
18.104.22.168/ 22.214.171.124 - server
126.96.36.199/ 255.255.248.0 - scope 1
188.8.131.52/ 255.255.255.0 - scope 2
184.108.40.206 -Default vlan
220.127.116.11 - Vlan 20
18.104.22.168 - Ip helper address on vlan 20
01-27-2014 12:44 PM
As well as the DHCP relay (which is enabled by default) each of the VLANs that have clients in them that need to receive and IP address from your DHCP server need a helper address - the address of your DHCP server.
i.e. Edge_1(vlan-77)# ip helper 10.10.10.10