Default Password HP Procurve Switch 2824 (118340 Views)
Reply
Occasional Contributor
Posts: 5
Registered: ‎07-30-2006
Message 1 of 4 (118,340 Views)

Default Password HP Procurve Switch 2824

[ Edited ]

Hi All,

We are fetching a problem. I need a help form you. We have a switch which is in the live running. I want to get in the HP Procurve Switch 2824. But I can not get in. I want to default user name and password. Or default configuration when this is new. Any one give me immediate response.

thanks
shibly

 

 

P.S. This thread has been moevd from Switches, Hubs, Modems (Legacy ITRC forum) to ProCurve / ProVision-Based. - Hp Forum Moderator

Honored Contributor
Posts: 1,022
Registered: ‎04-29-2006
Message 2 of 4 (118,340 Views)

Re: Default Password HP Procurve Switch 2824

Hi

NO default password is set when the switch is new.

The default configuration is quit simple:

One default Vlan (Vlan1) with IP DHCP enabled on this Vlan, and it has 2 users built in: Manager & Operator with NO password set but you can configure other user names (Optional).

If you have a password already set on this switch, and you have physical access to the switch,
press and hold the Clear button (on the front of the switch) for a minimum of one second to clear all password protection.

You can also use the Reset button together with the Clear button (Reset+Clear) to restore the factory default configuration for the switch. To do this:
1. Press and hold the Reset button.
2. While holding the Reset button, press and hold the Clear button.
3. Release the Reset button and wait for about one second for the Self-Test LED to start flashing.
4. When the Self-Test LED begins flashing, release the Clear button

This process restores the switch configuration to the factory default settings.

You can have a look on the following link that explains with pictures how to do so:
ftp://ftp.hp.com/pub/networking/software/Security-Oct2005-59906024-Chap02-Passwords.pdf

Good Luck !!!
Science for Everyone
Occasional Visitor
Posts: 2
Registered: ‎11-11-2008
Message 3 of 4 (118,340 Views)

Re: Default Password HP Procurve Switch 2824

Once cleara bastıgından emin ol - sona reset dokun cek - clear da elini 15 20 sn tut sabırlı ol
yanıp sonmeye baslayınca 3-5 sn daha bekle
aferin

i like it
Occasional Visitor
Posts: 1
Registered: ‎03-19-2015
Message 4 of 4 (8,406 Views)

Re: Default Password HP Procurve Switch 2824

This is by far the dumbest way to configure a switch.

 

I'm sorry.

 

We have numerous ProCurve E3800 24G-2XG's and configuring the usernames/passwords is the dumbest i've seen.

 

If you setup the device using CLI with the console cable and set a password, you're factory resetting as soon as you try to access the web interface. It'll ask you for the password and entering the password you setup in CLI won't work because you need a username.

 

But guess what? It doesn't give you an option under the initial CLI setup to set a user.

 

Set it up via Web Interface and set a password? It will log you out and ask you to login. Enter the password you just set, no dice.

The opinions expressed above are the personal opinions of the authors, not of HP. By using this site, you accept the Terms of Use and Rules of Participation.