Re: 5406 with HP J9685A ONE Adv H Svs zl Module-Win 2008-R2 and VLAN-Tag /802.1Q ? (446 Views)
Reply
Occasional Advisor
ley_1
Posts: 12
Registered: ‎06-05-2009
Message 1 of 3 (448 Views)

5406 with HP J9685A ONE Adv H Svs zl Module-Win 2008-R2 and VLAN-Tag /802.1Q ?

[ Edited ]

Hi@all

 

I have a question about the service modules zl
- Windows 2008 R2 j9666a-

How (and whether) I can use a vlan-tag on the 10GB interfaces.
(for a dl-server is the about the "HP adapter teaming"  - "ftp://ftp.compaq.com/pub/products/servers/networking/proliant-teaming-whitepaper-march 2008.pdf"

 



These are available but not on the module.

On the switch, it is easy to config

5406 / 15_06_0008
HP J9685A ONE Adv H Svs zl Module
config
vlan 1 tag h1
vlan 2 tag h1
---------------------
xx (hp-std-svcs-H) # show interfaces
 
port status
Port Windows Connection Name | Enabled status
----------------------------------------- + -------- -----
H1 Local Area Connection | Yes Up
H2 Local Area Connection 3 | Yes Up
Management Local Area Connection 2 | Yes Down

Is that possible, that I can use multiple VLAN tag on an interface (H1) to Windows2008 R2?

Also note that the Windows Server 2008 R2 supports 802.1Q VLAN tagging and the intel Nic also.
(Intel(R) 82598EB 10 Gigabit AT CX4 Network Connection)

but how?

Thank you
(Sorry for bad english,)
Thomas

Valued Contributor
Helper
Posts: 142
Registered: ‎10-19-2010
Message 2 of 3 (446 Views)

Re: 5406 with HP J9685A ONE Adv H Svs zl Module-Win 2008-R2 and VLAN-Tag /802.1Q ?

hi,

 

I don't know how service module show their "NIC" under your OS, but using Intel ProSet you can configure vlan easily.

 

Download :

http://www.station-drivers.com/forum/viewtopic.php?f=32&t=3412

http://www.station-drivers.com/page/intel%20lan-wan.htm

 

Configure :

http://support.dell.com/support/edocs/network/P29351/fr/proset.htm

 

 

Bye,

Trusted Contributor
Richard Litchfield
Posts: 266
Registered: ‎07-11-2003
Message 3 of 3 (411 Views)

Re: 5406 with HP J9685A ONE Adv H Svs zl Module-Win 2008-R2 and VLAN-Tag /802.1Q ?

The NICs in the ONE module are Intel 10Gb CX4 chipsets. Download the file AllNetworkAdapterDrivers_13_5.zip (maybe a newer version now) from the Intel website and install that.

 

I team/bond the 2 NICs into a 20Gb LACP connection, and run 802.1Q VLAN tags on top of that - works a treat! Make sure the matching ports in the switch are also configured to match

trunk e1-e2 trk3 lacp

The opinions expressed above are the personal opinions of the authors, not of HP. By using this site, you accept the Terms of Use and Rules of Participation.