2910al stack members not managing properly in stack when I upgrade from firmware w.14.38 to w.14.49 (664 Views)
Reply
Occasional Contributor
Switcher
Posts: 2
Registered: ‎09-21-2011
Message 1 of 3 (664 Views)

2910al stack members not managing properly in stack when I upgrade from firmware w.14.38 to w.14.49

Background: Stack works fine with the w.14.38 firmware. Commander has an address on the primary vlan, members have no addresses but are set up with their trunk uplink ports to the commander as tagged in the primary vlan (stacking protocol apparently works across the primary VLAN). Their primary vlan ID is the same as the commander's. The primary vlan is no longer Default vlan ID 1. The Commander has an admin password set. I then upgraded the firmware on the members & set it as boot default image, ending with the upgrade of the commander.  I have subsequently rebooted them all several times but the problem still occurs.

 

The problem: I can connect to the commander web interface fine, but  when I switch the dropdown to a member switch, all I get is the HTML  "page can't be displayed" message in the frame. I've checked the web agents on the members are enabled (plaintext not SSL). The 'show stack' option of the web interface shows all members as up.

If I connect over telnet to the Commander, and try to logon as admin it just hangs (perhaps because it would normally present an option just after logon to select the stack member I want to manage, but because stacking is messed up I think this is why it hangs here). If I logon as read-only and enable myself as Admin I can get in. When I view stacking (all) in the telnet menu system it says the members are up and connected. If I then view stacking (this switch) it hangs indefinately. If I then force disconnect the telnet session and go back in I can't then even run the menu utility 2nd time around  (I just get the menu banner appear and no menu ... it just hangs there!

Has anyone encountered this before? (I've reverted to the older secondary image for now and it's running OK on that).

Please use plain text.
Occasional Visitor
geertreijnders
Posts: 2
Registered: ‎01-11-2012
Message 2 of 3 (550 Views)

Re: 2910al stack members not managing properly in stack when I upgrade from firmware w.14.38 to w.14

Hi,

 

Did you ever resolve this issue? I'm having also the same problems with this firmware. Perhaps I need to roll back to version 14.38

 

Kind Regards,

 

Geert Reijnders

Please use plain text.
Trusted Contributor
Arimo
Posts: 269
Registered: ‎04-24-2009
Message 3 of 3 (521 Views)

Re: 2910al stack members not managing properly in stack when I upgrade from firmware w.14.38 to w.14

Hi guys

 

This is fixed in W.14.67. It's not available from the HPN website, but call support and you get the current W.14.69.


HTH,

Arimo
HP Networking Engineer
Please use plain text.
The opinions expressed above are the personal opinions of the authors, not of HP. By using this site, you accept the Terms of Use and Rules of Participation