2910al-48G: Resetting port statistics with SNMP set? (949 Views)
Reply
Occasional Contributor
JesperP
Posts: 3
Registered: ‎06-15-2012
Message 1 of 2 (949 Views)

2910al-48G: Resetting port statistics with SNMP set?

[ Edited ]

Hi,

 

I wondering if it possible to actually reset the 2910al-48G switch's port statistics permantly without having to reboot the switch, by using a SNMP set instead?

 

(If you do a "clear interface statistics" the statistics will only reset in during that session)

 

For example if I wanted to reset the tx dropped packets counter on port to 0:

 

snmpset.exe -u operator -c myCommunity -v 2c 10.0.0.10 ifOutDiscards.16 i 0

 

Sadly, I have currently no HP switches for lab testing, so I'm not to happy about just trying this command out in our office network switches.

 

Thanks

 

- Jesper

 

 

P.S. This thread has been moved from Comware-Based to  ProCurve / ProVision-Based. -HP Forum Moderator

Occasional Contributor
JesperP
Posts: 3
Registered: ‎06-15-2012
Message 2 of 2 (918 Views)

Re: 2910al-48G: Resetting port statistics with SNMP set?

[ Edited ]

Apparently this is not possible because the MIBs OIDs is using the data type "Counter32" or "Counter64" which is read-only.

 

But would be great if someone proved me wrong or came up with a work-around though.

The opinions expressed above are the personal opinions of the authors, not of HP. By using this site, you accept the Terms of Use and Rules of Participation.