2910 2 VLANs same subnet to Internet (316 Views)
Reply
Occasional Visitor
jpnels712
Posts: 1
Registered: ‎08-03-2012
Message 1 of 2 (316 Views)

2910 2 VLANs same subnet to Internet

I am currently working on setting up two VLANs (30 & 40) on a 2910 with the same subnet (10.234.43.x).  I can not get VLAN 30 or 40 to connect to the internet.

 

VLAN 1

Port 1 Untagged

Port 2-5 Untagged

 

VLAN 30

Port 1 Tagged

Port 6-10 Untagged

 

VLAN 40

Port 1 Tagged

11-15 Untagged

 

I had it working yesterday but had to do a factory reset do to a different problem.  Is there something in the CLI that I am missing?

Please use plain text.
Esteemed Contributor
paulgear
Posts: 655
Registered: ‎04-03-2011
Message 2 of 2 (301 Views)

Re: 2910 2 VLANs same subnet to Internet

It's very difficult to answer this without a lot more information, but in general it's not a good idea to use the same subnet on two different VLANs.  You can make it work by using the appropriate NAT on your router, but it's definitely not recommended.

 

Another general note: i've never found it necessary to do a factory reset on a ProCurve device.  If you have to resort to that, it's likely that you have some other problem.  I've never found any configuration that couldn't be completely reversed by running the appropriate CLI commands to reverse what i'd done previously.

Regards,
Paul
Please use plain text.
The opinions expressed above are the personal opinions of the authors, not of HP. By using this site, you accept the Terms of Use and Rules of Participation