Anybody know of conflicts with 3000page stacker/stapler bin and DUPLEX. (48 Views)
Reply
Occasional Contributor
Ron Walashek
Posts: 7
Registered: ‎01-26-2004
Message 1 of 1 (48 Views)

Anybody know of conflicts with 3000page stacker/stapler bin and DUPLEX.

Thanks for the help with embedding after a while I got the hang of using display functions.

This is in the question before but it wasn't stated very well. I added bin selection and stapling to a setup file already in use with with DUPLEX and the duplex stopped working. Duplex is inherited from NPCONFIG global setup file. The following is the device specific setup file.
Prior script (s0p16.66h8.50v0s0b0T
&a1L
&l1s6c81F
New Script %-12345X
@PJL SET OUTBIN=OPTIONALOUTBIN2
@PJL SET FINISH=STAPLE
@PJL SET STAPLEOPTION=ONE
%-12345X

I have also set DUPLEX in the PCL "&l" line with 1s and in the PJL area with PJL SET DUPLEX=ON and PJL SET BINDING=LONGSIDED. If I pull the bin selection out it duplexes. Is there and order these need to apply?
Please use plain text.
The opinions expressed above are the personal opinions of the authors, not of HP. By using this site, you accept the Terms of Use and Rules of Participation