Laserjet 600 M602 network disconnect (291 Views)
Reply
Occasional Collector
Dan Schwartz
Posts: 2
Registered: ‎12-01-2004
Message 1 of 2 (291 Views)

Laserjet 600 M602 network disconnect

 

I have 21 Laserjet 600 M602 printers deployed in labs around our university campus.  About 1/2 of these printers will stop responding to pings (and any other network traffic) after a day or two.  The others seem to stay alive.  

 

A powercycle of the printer will bring it back, but the users in the labs don't realize that, and it's a problem.  The printer still says "ready", and appears to be alive, but isn't reachable via the network interface.

 

The only obvious thing about the failing printers is that they were purchased / manufactured more recently than the others.   

 

Any ideas?   

 

Thanks - Dan Schwartz, Lehigh University

 

Occasional Collector
Dan Schwartz
Posts: 2
Registered: ‎12-01-2004
Message 2 of 2 (275 Views)

Re: Laserjet 600 M602 network disconnect

It turns out that some of the printers that are failing have not been renewing their dhcp leases.   Our network switches automatically block the ports which don't have valid dhcp connections, so these printers work until the lease times out and then get dropped from the network.   I'm not sure why only some of them are having this problem.   Perhaps it's a configuration issue as well as a jetdirect firmware defect.   It will take some more investigation.  

 

 

 

The opinions expressed above are the personal opinions of the authors, not of HP. By using this site, you accept the Terms of Use and Rules of Participation.