LJ 4250, error 51.20 (3576 Views)
Reply
Advisor
Teresa Bochnak
Posts: 27
Registered: ‎03-28-2006
Message 1 of 4 (3,576 Views)
Accepted Solution

LJ 4250, error 51.20

I have a HP LJ 4250 printer, it is giving me a 51.20 error, I looked in the manual, and all its says it to recycle power, The swing plate assembly and the fuser was just replaced. I was getting this error before these items were replaced. I seen one article mentioning a beam detect error and or laser error, but i only found on small documentation on this can't find anything else that would help me resolve this issue.
Honored Contributor
Mark Froggatt
Posts: 1,741
Registered: ‎07-25-2006
Message 2 of 4 (3,576 Views)

Re: LJ 4250, error 51.20

Teresa

its an error with the laser scanner unit
1 Press ( SELECT button) to continue.
2 Turn the printer off and then on.
3 Reseat the connectors between the
laser/scanner and dc controller
PCA (J83 and J84).
4 Replace the laser/scanner assembly.
See Laser/scanner assembly.
5 Replace the dc controller PCA. See
Dc controller PCA.

Mark
Outstanding Contributor
DavidZuts
Posts: 15,299
Registered: ‎02-27-2006
Message 3 of 4 (3,576 Views)

Re: LJ 4250, error 51.20

If nothing from above works and the printer is no longer in warranty, it is possible if the printer is being used in a very dirty or dusty enviornment that the lens and optics of the laser/scanner are so full of debris that the beam detect error occurs. You can remove the top cover and the big black box in the center is the laser scanner assembly. Remove the screws securing the top cover of the laser scanner and remove and clean up all the optics to include the main mirror in the front. I usually use a damp q tip and for the mirror I slide up from toner cartrdige shutter area and observe from the top as it cleans the mirror. Removing the complete assembly on this model is not easy since there are a couple of cables going to the dc controller which are difficult to remove so removing the top of the assembly is easier.
Advisor
Teresa Bochnak
Posts: 27
Registered: ‎03-28-2006
Message 4 of 4 (3,576 Views)

Re: LJ 4250, error 51.20

Thanks, These solutions should help me alot, i thought it had something to do with that, but wasn't exactly sure.
Thanks
Again
The opinions expressed above are the personal opinions of the authors, not of HP. By using this site, you accept the Terms of Use and Rules of Participation.