How do I reset (cold start) Laser Jet P2035n ? (53480 Views)
Reply
Occasional Advisor
charger
Posts: 10
Registered: ‎06-28-2007
Message 1 of 3 (53,480 Views)

How do I reset (cold start) Laser Jet P2035n ?

I neet to reset the Network Information to factory settings.

I've tried all the recommendations I could find here for similar printers (power on while holding down GO button, or power on while holding down Cancel button, none work!)

I put in a Static IP for my Solaris system which can't seem to reach it, and now I can't even get to the printer embeded configuration web page via my Windows system because the static IP I enterd for Solaris is unreachable by my Windows netork!

I need to get it back to a 192.168.168.168 subnet!

HELP!

(why is the reset information not available in the manual PDF?)
Occasional Advisor
charger
Posts: 10
Registered: ‎06-28-2007
Message 2 of 3 (53,326 Views)

Re: How do I reset (cold start) Laser Jet P2035n ?

I was able to search down the answer (on the HP support web site).

To reset to factory settings a P3025n printer:

1. power it down
2. hold down BOTH buttons (go and cancel)
3. power on (still holding down buttons)
4. all lights come on at same time, success
5. power cycle again and it'll get a new IP on 192.168.168.xxx
Frequent Advisor
roy Hanson
Posts: 33
Registered: ‎07-09-2008
Message 3 of 3 (1,112 Views)

Re: How do I reset (cold start) Laser Jet P2035n ?

3 bottom light flashing at turn on. Fatal Error.

we recently replaced the fuser assembly.

 

also, loud rumbling noise from rear of printer.

 

The opinions expressed above are the personal opinions of the authors, not of HP. By using this site, you accept the Terms of Use and Rules of Participation.