09-04-2013 02:13 AM
I work in an office where we need different custom paper formats (smaller than A4) in different paper trays of the same printer. I have set up custom formats for each tray on our newly installed Laserjet 3015x and in the application we use. However, without any discernable logic, sometimes a format error message appears on the printer display asking to insert paper of set format into the tray. You can override this by pressing OK once, then selecting the same tray, then pressing OK again - and it prints just fine. But of course it is no long-term solution to always run to the printer and pressing buttons for each time you print. I have tried to change formats in the application, but this occurs quite randomly. It worked fine, after a printer restart it does not. On one PC it works, on another with exactly the same settings it does not...
I would appreciate any hints on how to disable this, I have not found any setting to do so...
Thank you very much in advance! :-)
09-04-2013 04:31 AM
09-06-2013 08:47 AM
Actually in the current setting the correct tray is chosen (2), so it asks for paper of that format to be inserted into that tray. Currently it works again, so it is really not following any logic anymore. No settings have been changed since, and the danger that it does not work again once more is great. So I really would need a way to disable this warning.
Maybe it is due to the fact, that the paper in question is borderline small, a little smaller than 110x230 mm in fact...
09-10-2013 10:45 AM
There is a workaround you can try. Put the papers in tray 1 and configure the Tray to Any Size Any type . It will pickup the papers without prompting. On the hindsight it will be pickup any paper.