Re: 4345mfp not printing legal or duplexing (260 Views)
Reply
Visitor
Ifshmn
Posts: 4
Registered: ‎01-13-2014
Message 1 of 9 (324 Views)

4345mfp not printing legal or duplexing

I have a 4345 printer, obviously, that will not eject legal size paper or print duplex.  All other functions appear to work perfectly.

 

The paper stops in the top cover area of the feed system, between the reversing separation-guide assembly and Reversing assembly.

 

I have swapped the following assemblies with a fully functional mfp:

reversing separation-guide assembly

Reversing assembly

Power-factor-correction (PFC) power supply

Engine power supply

and finally the DC controller

 

The error is consistent: "13.33.00"

When performing a maual sensor test, PS109 responds the same on both the functioning and non-functioning MFPs.

 

I just don't know what else to do.

 

 

Please use plain text.
Super Advisor
Oldscout
Posts: 358
Registered: ‎06-12-2013
Message 2 of 9 (318 Views)

Re: 4345mfp not printing legal or duplexing

Start with the simple things first, replace the paper feed tires, then check that the right size paper is registered in the tray. The error your getting says that the paper is not getting to PS 109 in time, since you are telling me it doesn't check as good I would replace it. Part # RM1-1570-000CN
Please use plain text.
Outstanding Contributor
DavidZuts
Posts: 15,104
Registered: ‎02-27-2006
Message 3 of 9 (318 Views)

Re: 4345mfp not printing legal or duplexing

Look up in the cover towards the right side of the printer. When you duplex or use legal paper it moves all the way to the right in the upper cover and sometimes there is a piece of paper stuck at the end on the right side that prevents the legal paper from going far enough. Had 2 of them, the first took me over 1 hour to figure out. The second took all of 10 seconds.
Please use plain text.
Valued Contributor
Imagenet_Tech
Posts: 360
Registered: ‎07-09-2012
Message 4 of 9 (285 Views)

Re: 4345mfp not printing legal or duplexing

Hello, have you done a component test to see if all the motors and things turning?

Please use plain text.
Visitor
Ifshmn
Posts: 4
Registered: ‎01-13-2014
Message 5 of 9 (276 Views)

Re: 4345mfp not printing legal or duplexing

Thank you all for your responses and help.

 

I've replaced the entire Reversing assembly, which includes the PS109 sensor.

 

When I peform the manual sensor test, both on this mfp and another that is fully functional, "K" doesn't change from 0 to 1, like "H" does, but the screen flashes whenever I press on the PS109.  This leads me to belieive that the sensor is functioning properly.

 

I have run the component tests on all parts and they are functioning properly.

 

I have checked for blockages/paper in the top cover area and cannot see any, nor does shoving cardstock in there indicate any blockage.

Please use plain text.
Valued Contributor
Imagenet_Tech
Posts: 360
Registered: ‎07-09-2012
Message 6 of 9 (273 Views)

Re: 4345mfp not printing legal or duplexing

So it stops before hitting the reverse assembly? Does it stop dead in its tracks, or does the paper hit and bunch up? I am wondering if something maybe unplugged. Had a similar issue come to find out the duplexing connector was not seated properly.

Please use plain text.
Visitor
Ifshmn
Posts: 4
Registered: ‎01-13-2014
Message 7 of 9 (266 Views)

Re: 4345mfp not printing legal or duplexing

I have attached a couple of photos.

 

The first is where it stops.

 

The second, if you can see it, is the only damage to the page at all, and it's consistent.  A slight tear on the bottom to the right.

Please use plain text.
Visitor
Ifshmn
Posts: 4
Registered: ‎01-13-2014
Message 8 of 9 (260 Views)

Re: 4345mfp not printing legal or duplexing

New info:

Test 1: removed duplexer, ran paper path test on legal and it worked.

Test 2: replaced duplexer, ran paper path test on legal and it failed.

Test 3: removed duplexer, ran paper path test on legal and it still failed.

I power cycled the printer between each test.
Please use plain text.
Outstanding Contributor
DavidZuts
Posts: 15,104
Registered: ‎02-27-2006
Message 9 of 9 (241 Views)

Re: 4345mfp not printing legal or duplexing

I still think you have a sheet of paper stuck up there. Remove that plastic cover that has the pictures of the printer and the paper should be right behind it.
Please use plain text.
The opinions expressed above are the personal opinions of the authors, not of HP. By using this site, you accept the Terms of Use and Rules of Participation