error 0c0032 00000003 and 1050c (2419 Views)
Occasional Visitor
Posts: 1
Registered: ‎06-11-2002
Message 1 of 3 (2,419 Views)

error 0c0032 00000003 and 1050c

What can I do to correct thsi error.

0c0032 00000003

in a 1050c
Respected Contributor
Posts: 242
Registered: ‎10-21-2001
Message 2 of 3 (2,419 Views)

Re: error 0c0032 00000003 and 1050c

Hi Anibal-

According to the service manual the 0C0032 System Error indicates that the Drop detector is not calibrated for all printheads.

The corrective action is to:

1)Perform the Service Station Calibration.

To enter the service calibration menu do the following.

-Once the message "Ready" is displayed on the front-panel, scroll to the "Printer Setup Options" icon and press the ENTER key.
-Once inside the "Printer Setup Options" menu, use the ARROW keys to scroll to the "Utilities" menu display and press the ENTER key.

Note-Make sure that you are in the Full menu mode because otherwise you will not be able to access the "Service Tools" submenu.

-Once inside the "Utilities" menu, press the UP and ENTER keys together. You are now in the SERVICE TOOLS menu.

-Use the Arrow keys to scroll to the "Service Calibrations" menu and press the Enter key.

-Then scroll through until you see the Service Station Calibration and press ENTER

Follow the instructions to perform the calibration.

2)If the problem persists replace the Drop Detector Assembly.

3) If the problem persists, replace the Electronics Module.

Occasional Visitor
Posts: 2
Registered: ‎05-16-2005
Message 3 of 3 (2,419 Views)

Re: error 0c0032 00000003 and 1050c

0c0032-00000003 appeared me and I made the following steps:

printer setup -->"Utilities" -->"UP" and "Enter" keys TOGETHER SIMULTANEOUSLY.
"Service Tools"-->"Service Calibrations"-->"Service Station"
This error disappeared and appeared this 0c0032-00000004. What I make??
thank you very mutch
The opinions expressed above are the personal opinions of the authors, not of HP. By using this site, you accept the Terms of Use and Rules of Participation.