designjet 1055cm receives but does not print (393 Views)
Reply
Occasional Visitor
TT3D
Posts: 1
Registered: ‎07-21-2010
Message 1 of 1 (393 Views)

designjet 1055cm receives but does not print

Hi My plotter is connected via serial port LPT1 with a windows xp home.

 

It plotted once using an Adobe plot,

 

Now it only shows up receiveing the file on the status screen and then just does not plot.

 

The configuration file prints okay so the plotter seems okay.

 

I reduced the time delay but this made no differecence.

 

I have tried a test print page in the printer properties, again receives but does not print. ?

 

Any help would be appreciated

The opinions expressed above are the personal opinions of the authors, not of HP. By using this site, you accept the Terms of Use and Rules of Participation.