Re: Yellow warning light and the three icons all flashing Designjet 110 plus nr (260 Views)
Reply
Occasional Visitor
CasaBella
Posts: 2
Registered: ‎12-16-2013
Message 1 of 4 (335 Views)

Yellow warning light and the three icons all flashing Designjet 110 plus nr

I have a Designjet 110 plus nr printer.  When I turn on the printer, it begins to go through it's startup and in the middle it stops, then the yellow warning light and state of sheet icon, Press a key icon and Paper jam icon start flashing.  Have turned it off, unplugged, clean rear contacts, cleared all paper with no results.  Would you have any other ideas or suggestions.

Occasional Visitor
CasaBella
Posts: 2
Registered: ‎12-16-2013
Message 2 of 4 (310 Views)

Re: Yellow warning light and the three icons all flashing Designjet 110 plus nr

It is showing a code 167 "Initializing Printhead Control" Error Message in Start Up Track Mode.  Any Ideas yet?

 

 

Outstanding Contributor
DavidZuts
Posts: 15,317
Registered: ‎02-27-2006
Message 3 of 4 (298 Views)

Re: Yellow warning light and the three icons all flashing Designjet 110 plus nr

Have you removed all the printheads and ink tanks and then started the plotter. See if it comes to where it asks for those items and you then place each one in one at a time to see if one of them is causing the problem.
Frequent Advisor
dean stacey
Posts: 51
Registered: ‎04-16-2008
Message 4 of 4 (260 Views)

Re: Yellow warning light and the three icons all flashing Designjet 110 plus nr

I'm having the same issue. The printer goes through the motions with all ink carts and printheads removed and just before the error appears there is a click noise from the feed mechinism then it shuts down.

The opinions expressed above are the personal opinions of the authors, not of HP. By using this site, you accept the Terms of Use and Rules of Participation.