Error 22.1.10 in Designjet T1300ps (147 Views)
Reply
Occasional Contributor
Ishola
Posts: 5
Registered: ‎07-21-2014
Message 1 of 4 (147 Views)

Error 22.1.10 in Designjet T1300ps

I have a designjet T1300 that is new during installation it displays error 22.1.10. We have changed The PCA, Ink station, service station, and connectiing board but is still displaying the error. We need your help. regards.

Please use plain text.
Honored Contributor
timwj1
Posts: 908
Registered: ‎08-11-2010
Message 2 of 4 (143 Views)

Re: Error 22.1.10 in Designjet T1300ps

I'm not sure where you are located, but all new plotters have a one year on site warranty, have you contacted HP?

If you feel my reply has assisted you in repairing your printer please press the kudos star icon on the left and mark as problem solved. Thank you!

TJ
Please use plain text.
Occasional Contributor
Ishola
Posts: 5
Registered: ‎07-21-2014
Message 3 of 4 (136 Views)

Re: Error 22.1.10 in Designjet T1300ps

I am located in Nigeria, the plotter was imported from US, not covered by warranty in Nigeria.
Please use plain text.
HP Pro
Mike-T
Posts: 5
Registered: ‎08-05-2014
Message 4 of 4 (88 Views)

Re: Error 22.1.10 in Designjet T1300ps

Hi Ishola,

Try these recommendations to see if they help with the error you're getting. 


Check that the cables between the Ink Supply Station and the Engine PCA are not
damaged and are properly connected. In case of any damage, replace the cable.


NOTE: Check the Data Harness and ISS Harness Cable are connected in the right
position onto the Engine PCA. These two connectors can be swapped by mistake causing
a SE 22.1:10. (The connector of the Data Harness has a blue label, and the corresponding connector on the
Engine PCA is also blue.)

 

Hope this helps,


Mike

 

_________________

I work on behalf of HP.
Please use plain text.
The opinions expressed above are the personal opinions of the authors, not of HP. By using this site, you accept the Terms of Use and Rules of Participation