Re: Designjet 500 severe error. (71 Views)
Reply
Occasional Visitor
enginternWeaber
Posts: 2
Registered: ‎06-11-2014
Message 1 of 4 (125 Views)

Designjet 500 severe error.

I just replaced the drive belt was finished and turned it on.

This is what the display read.

 

Severe error: 0x301002

task: tMech

file: sequence.c

line: 758

Occasional Visitor
enginternWeaber
Posts: 2
Registered: ‎06-11-2014
Message 2 of 4 (124 Views)

Re: Designjet 500 severe error.

What is my problem ?
Valued Contributor
D Hook1
Posts: 465
Registered: ‎04-21-2009
Message 3 of 4 (101 Views)

Re: Designjet 500 severe error.

Sounds like a service station error. This link will give some info:

http://www.computercarefiles.com/TWI_Docs/bpp90134/default.html

This is a link to the service station replacement. http://www.computercareonline.com/documents.php

Google the severe error code and you'll find more.
Outstanding Contributor
DavidZuts
Posts: 15,311
Registered: ‎02-27-2006
Message 4 of 4 (71 Views)

Re: Designjet 500 severe error.

If you just replaced the belt make sure you did not pinch the big gray ribbon cable that goes from the board on top thru the side to the electronics module. Very common to pinch that cable which causes a service station error.
The opinions expressed above are the personal opinions of the authors, not of HP. By using this site, you accept the Terms of Use and Rules of Participation.