Re: Designjet 230 D Unknown panel light error code then no power. (135 Views)
Reply
Occasional Contributor
Posts: 3
Registered: ‎06-11-2014
Message 1 of 3 (182 Views)
Accepted Solution

Designjet 230 D Unknown panel light error code then no power.

10 + year old Plotter worked flawlessly until last week,, it would not plot but all panel lights lit properly. I turned off, to re-boot, but whhen it came on again all 8 lights blinked once then off/nothing. When I turned off the lights blinked again. I replaced the cartridge but NG. Then I took a chance and replaced the power supply in the ECM but it did not fix and the plotter still blinks on and off. Any advice is appreciated.

Occasional Contributor
Posts: 3
Registered: ‎06-11-2014
Message 2 of 3 (155 Views)

Re: Designjet 230 D Unknown panel light error code then no power.

I found fine steel wool type dust surrounding one transistor attached to the heat sink on the main logic board. Once cleared with a puff of air all working again. 

Valued Contributor
Posts: 479
Registered: ‎04-21-2009
Message 3 of 3 (135 Views)

Re: Designjet 230 D Unknown panel light error code then no power.

Thanks for following up with the solution. Never would've thought to look there.
The opinions expressed above are the personal opinions of the authors, not of HP. By using this site, you accept the Terms of Use and Rules of Participation.