Designjet 1050C error 0C0032 00000004 (3233 Views)
Reply
Occasional Visitor
CA1325342
Posts: 2
Registered: ‎09-15-2005
Message 1 of 4 (3,233 Views)

Designjet 1050C error 0C0032 00000004

Could someone please tell me what this error number means? The plotter seems to work fine otherwise. Also, is there a list somewhere explaining what all the different error messages mean?
Esteemed Contributor
Andie M ª Ð T ª Z Finni
Posts: 519
Registered: ‎09-09-2003
Message 2 of 4 (3,233 Views)

Re: Designjet 1050C error 0C0032 00000004

There error you are getting has to do with the Drop Detect

If you take a look at the right side where the printhead sit while they are parked. The Drop Detect is there.


You will need to pull the cleaners towards you after that pullthe carriage out. You will see a little hole there and you will need to clean it with water and a lint free cloth.

After that you will have to run the service station calibration
Hit enter on Printer Icon
Move down to Utilities and hit enter
now you will have to hit the up arrow and enter at the same time
Then go to service calibrations
then go to service station cal.

Make sure that you have replaced any printhead that are expired or not producing poor quality also

If you have anymore question let me know


Regards

MaDTaZ
Getting fired is nature's way to telling you that you had the wrong job in the first place. Hal Lancaster
Occasional Visitor
CA1325342
Posts: 2
Registered: ‎09-15-2005
Message 3 of 4 (3,233 Views)

Re: Designjet 1050C error 0C0032 00000004

>You will need to pull the cleaners towards you after that pullthe carriage out. You will see a little hole there and you will need to clean it with water and a lint free cloth.

Thanks for your reply. I don't know which are "the cleaners" you mention, or the carriage. Could you please explain a little what they look like?
Esteemed Contributor
Andie M ª Ð T ª Z Finni
Posts: 519
Registered: ‎09-09-2003
Message 4 of 4 (3,233 Views)

Re: Designjet 1050C error 0C0032 00000004

The cleaners are the parts behind the right side door on the designjet

All you have to do it pull them towards you and then you can grabe the carriage and move it out


Regards

MaDTaZ
Getting fired is nature's way to telling you that you had the wrong job in the first place. Hal Lancaster
The opinions expressed above are the personal opinions of the authors, not of HP. By using this site, you accept the Terms of Use and Rules of Participation.