Re: DesignerJet 500 02:10 error - severe error 0X402000C (126 Views)
Reply
Occasional Visitor
The_Doctor
Posts: 1
Registered: ‎06-17-2014
Message 1 of 2 (140 Views)

DesignerJet 500 02:10 error - severe error 0X402000C

Good afternoon,

 

I had a Designer Jet 500 come in today with a 02:10 error and a severe error 0X402000C; task : tmech file : Pewcntrl.c

on line 79. I was wondering if anybody had seen this in the past? According to the gentleman there was a possilbe lightening strike on the building where it was plugged in (and of course no surge protection) so I am leaning towards the main control board, but, I figure it's better to see if anybody else had any ideas before I just started throwing parts at it.

Honored Contributor
timwj1
Posts: 946
Registered: ‎08-11-2010
Message 2 of 2 (126 Views)

Re: DesignerJet 500 02:10 error - severe error 0X402000C

This is what the service manual states and a good starting point.

 

System Error: 02:10
Problem
Description:
Carriage failure. The possible cause could be:
1. The Carriage PCA is not compatible with the rest of the Printer.
2. The Carriage ASIC has problems initializing.
3. The +2.5V reference voltage generated in the Carriage PCA is
out of range.
4. One of the Carriage ASIC’s cannot be found within the Serial
Bus that connects the Electronics Module to the Carriage.
5. One of the Carriage ASIC’s did not respond to the Serial Bus that
connects the Electronics Module to the Carriage Assembly.
Corrective Action: Replace the Carriage Assembly ⇒ Page 8-78.

If you feel my reply has assisted you in repairing your printer please press the kudos star icon on the left and mark as problem solved. Thank you!

TJ
The opinions expressed above are the personal opinions of the authors, not of HP. By using this site, you accept the Terms of Use and Rules of Participation.