DesignJet T2300 printhead replacement loop (265 Views)
Reply
Occasional Collector
tim_sbs
Posts: 2
Registered: ‎08-01-2014
Message 1 of 4 (265 Views)

DesignJet T2300 printhead replacement loop

Got an error to replace the MK-Y printhead, so I purchased a new one and installed it according to the instructions.  After I get the scanner lid closed it starts the 10 minute process, but reaches 100% after 7 minutes then starts the replacement procedure over again.  If I redo it, the loop continues; if I cancel or power-cycle the machine, it throws an error "printhead replacement incomplete" which re-starts the loop.  In addition, after I replaced the MK-Y, it's giving me a different replacement error on the PK-M printhead.

 

I'd like to avoid paying a service fee if at all possible, has anybody else run into this or have any ideas?  I've tried searching but had no luck finding a solution.

Valued Contributor
Mikeg81
Posts: 323
Registered: ‎08-27-2012
Message 2 of 4 (239 Views)

Re: DesignJet T2300 printhead replacement loop

Hi,

 

Try this

 

- Clean the electrical contacts on the carriage. If there is a bad contact the printe might not recognize the PH

- Clean the Drop Detector. Clean the top part of it, not inside. (See picture)

- Make sure the ik levels on the ink cartridges are above 30%

- If you are using non-HP ink, try HP ink

 

DD.jpg

 

Best regards

 

Mike G

Respected Contributor
gringod
Posts: 285
Registered: ‎07-05-2005
Message 3 of 4 (212 Views)

Re: DesignJet T2300 printhead replacement loop

Hi, If the printer thinks there is not enough ink in the cartridges to do the printhead replacement, it will keep saying the "incomplete".

Make sure your cartridges are over half way full.

If they feel light replace them for the printhead repalcement them put them back later.

Occasional Collector
tim_sbs
Posts: 2
Registered: ‎08-01-2014
Message 4 of 4 (203 Views)

Re: DesignJet T2300 printhead replacement loop

@Mikeg81 - Thank you, that got the installation for the initial problem printhead finished!  Didn't even notice the bit of gunk when I was replacing it, but once I knew where to look I got it cleaned up.  

 

@gringod - That is my next step.  It doesn't make sense to me, but if that's what it takes, that's what we'll do.

 

Thanks!

The opinions expressed above are the personal opinions of the authors, not of HP. By using this site, you accept the Terms of Use and Rules of Participation.