DesignJet 600 - The plotter breaks up the calibration of the pins ( the cartridges ) (69 Views)
Reply
Occasional Contributor
archiwill
Posts: 3
Registered: ‎05-30-2014
Message 1 of 1 (69 Views)

DesignJet 600 - The plotter breaks up the calibration of the pins ( the cartridges )

Dear Ladies and Gentlemen,

I have a problem with the HP Plotter DesignJet 600
I get an error message: System error 010029 000000ea.

The plotter breaks up the calibration of the pins ( The cartridges )

 

And Then the following message : New Left cartridge insertion.
But the two cartridges are new and ok.

If there is an error in the calibration values -
How do I delete the calibration values?
 

 

Can I reset the plotter and how?


In advance thank you!

Dr. Joachim Willmann

The opinions expressed above are the personal opinions of the authors, not of HP. By using this site, you accept the Terms of Use and Rules of Participation.