DesignJet 110 - Configuration manual Hard Reset? (5908 Views)
Reply
Occasional Visitor
MurphyBrown1988
Posts: 1
Registered: ‎07-02-2010
Message 1 of 2 (5,908 Views)

DesignJet 110 - Configuration manual Hard Reset?

Hello All.

Ive got a Designjet 110 that Im connecting to a new computer via ethernet network.

Ive brought up the printers old IP/adress via typing it into the adress bar of a broswer and want to change it to that of the new computer to get the printer and PC talking. But to change anything on the configuration page it is protected by an aministration pasword, which no-one including our IT man can recall.

 

*Is there a method on the printer itself that I can use to erase the non-volatile memory so I can reconfigure from scratch? 

 

*Is this the same as a hard reset and will this remove the appropriate config data and password protection - ready to accept a new IP adress?

 

Anyhelp would be most appreiciated, as I'm up against bit of a wall here

thankyou

regards

Murphy 

Outstanding Contributor
DavidZuts
Posts: 15,492
Registered: ‎02-27-2006
Message 2 of 2 (5,886 Views)

Re: DesignJet 110 - Configuration manual Hard Reset?

See the attached.

The opinions expressed above are the personal opinions of the authors, not of HP. By using this site, you accept the Terms of Use and Rules of Participation.