hpux migration from 11.11 to 11.23 (172 Views)
Occasional Contributor
Posts: 3
Registered: ‎02-29-2008
Message 1 of 3 (172 Views)

hpux migration from 11.11 to 11.23

Hello everybody, I will migrate an hpux 11i v1 to hpux 11i v2 in rp4440 server.. my question is where can I find a procedure for make this? is with a patches, or is with a special media or what?.. my server also contains an oracle database?.. where can I see a compatibility table for firmware, software an all support in this scenary?

Thank you,
Honored Contributor
Posts: 13,900
Registered: ‎06-21-2000
Message 2 of 3 (172 Views)

Re: hpux migration from 11.11 to 11.23

Start here:

HP-UX 11i v2 Installation and Update Guide: HP Integrity Servers and HP 9000 Servers
PDF version - http://docs.hp.com/en/5992-1978/5992-1978.pdf

You will need to order the HP-UX 11iv2 media for your server, assuming you have a software support contract. The install guide above should answer your questions concerning firmware and HP-UX software.

You also need to verify with Oracle that the version of the DB you are running is supported. At a minimum, you will need to relink Oracle after you have updated to HP-UX 11iV2.
Honored Contributor
Posts: 1,501
Registered: ‎11-22-1999
Message 3 of 3 (172 Views)

Re: hpux migration from 11.11 to 11.23


Adding to that, here is the firmware information you may want to zoom into


If you plan to install or update HP-UX 11i v2 (B.11.23) from an HP-UX 11i v1 (B.11.11) PA-RISC system, HP recommends you update the firmware on your system first.

For a matrix of system firmware for I/O adapters with HP-UX 11i v2 (B.11.23) boot support, as well as the minimum firmware requirements for HP-UX 11i v2, refer to the documents at http://docs.hp.com/en/hw.html#System%20Firmware

Problem never ends, you must know how to fix it
The opinions expressed above are the personal opinions of the authors, not of HP. By using this site, you accept the Terms of Use and Rules of Participation.