Re: scope extract of process data (127 Views)
Reply
Occasional Advisor
Dave Botkin
Posts: 13
Registered: ‎06-30-2002
Message 1 of 3 (127 Views)

scope extract of process data

While extracting process data on a particular job that was having performance problems, I found one pin that had a large value in a field called "runtime". The 5.0 manual states Upon reading the 5.0 manual it states RUNTIME Total process execution time until end of
interval.
I am not quite sure what this means.
The value there was 12000 seconds,which is 200 minutes or 3.3 hours. The pin consumed no cpu seconds, and did no I/O.

Please use plain text.
Honored Contributor
Chuck Ciesinski
Posts: 830
Registered: ‎10-03-2000
Message 2 of 3 (127 Views)

Re: scope extract of process data

Dave,

From which LaserRx screen are you extracting the data from?

Is this a batch process? If so, my guess, based on your initial comments it's from logon time...

Needing more info,

Chuck Ciesinski
"Show me the $$$$$"
Please use plain text.
Occasional Advisor
Dave Botkin
Posts: 13
Registered: ‎06-30-2002
Message 3 of 3 (127 Views)

Re: scope extract of process data

This data is coming from a scope extract batch run of process data. The particular process is running under a batch job. We do not have LASER/rx. This is report data. I take the data from the report and put it into an excel spreadsheet. It is attached below.
Please use plain text.
The opinions expressed above are the personal opinions of the authors, not of HP. By using this site, you accept the Terms of Use and Rules of Participation