Re: UNIX Resources. Cannot initialize (739 Views)
Reply
Respected Contributor
rpagadala09
Posts: 382
Registered: ‎11-19-2010
Message 1 of 4 (761 Views)
Accepted Solution

UNIX Resources. Cannot initialize

Hi Guys,

 

Even though My UNIX administrator started rstat daemon, I am still getting the below error.

 

 Monitor name: UNIX Resources. Cannot initialize the monitoring on 172.30.8.170. Error while creating the RPC client. Ensure that the machine can be connected and that it runs the rstat daemon (use rpcinfo utility for this verification). Detailed error: RPC: Failed to create RPC client.

RPC-TCP: Failed to establish RPC server address.

 

Earlier I did the load testing on QA Environment at that time when my UNIX administrator started rstat daemon for the UNIX, it worked.

 

But now the environment is the Performance cluster. So when I am trying to add the UNIX resources as monitor, I am getting the above Issue.

 

My UNIX administrator performed all the steps explained in the Controller reference guide (Chapter 25)

 Does anybody encounter the same problem?

 

Please advise me!

 

Thanks,

Raj

 

Respected Contributor
Prashanth T
Posts: 244
Registered: ‎12-11-2008
Message 2 of 4 (739 Views)

Re: UNIX Resources. Cannot initialize

There could be a problem with your firewall settings on the controller machine that prohibits you from monitoring the UNIX machine. Take a look at that and see if your firewall is blocking the communication.

 

Thanks

Prashanth Thimmavajjala

HP Expert
Suerte13cr
Posts: 736
Registered: ‎09-14-2011
Message 3 of 4 (731 Views)

Re: UNIX Resources. Cannot initialize

You can also check this article for reference:

 

http://support.openview.hp.com/selfsolve/document/KM174027

 

Regards,

Mario.

HP LR/PC Support

If you are customer you can try posting on our internal forums for more personalized support.

LoadRunner:
http://h30499.www3.hp.com/t5/LoadRunner-Support-Customer/bd-p/loadrunner-support-customer-forum

Performance Center:
http://h30499.www3.hp.com/t5/Performance-Center-Support/bd-p/performance-center-support-customer

How to:
http://www.youtube.com/watch?v=4ChlysWupWM

If you find that this or any post resolves your issue, please be sure to mark it as an accepted solution.
Respected Contributor
rpagadala09
Posts: 382
Registered: ‎11-19-2010
Message 4 of 4 (682 Views)

Re: UNIX Resources. Cannot initialize

Hi All,

 

Solution :  IT opened the firewall.

 

 

Thanks,

Raj

The opinions expressed above are the personal opinions of the authors, not of HP. By using this site, you accept the Terms of Use and Rules of Participation.