Re: Sitescope monitor state after a Performance Center 11 test run (225 Views)
Reply
Valued Contributor
L Pennington
Posts: 65
Registered: ‎12-17-2008
Message 1 of 4 (261 Views)

Sitescope monitor state after a Performance Center 11 test run

Using ALM Performance Center 11 with SiteScope 11.01 topologies to do the performance metric collection.

All the monitors are disabled once you have setup a topology. When you start a test run the monitors are enabled. I would therefore think they should be disabled after the end of the test run, but they stay enabled.

 

Does anyone know if this is the expected behaviour? It means SiteScope quickly becomes overloaded because multiple topology metrics are continuously running all the time after they are first run. Shouldn't really expect Perf Center users to have to go into SiteScope and manually disable them after each run.

 

Please use plain text.
HP Expert
KMadan
Posts: 1,074
Registered: ‎05-27-2009
Message 2 of 4 (240 Views)

Re: Sitescope monitor state after a Performance Center 11 test run

Please check whether 'enable montors' option in Topology configuration is set to 'always'.


Madan
Please use plain text.
Valued Contributor
L Pennington
Posts: 65
Registered: ‎12-17-2008
Message 3 of 4 (225 Views)

Re: Sitescope monitor state after a Performance Center 11 test run

No it is set to Automatically

Please use plain text.
HP Expert
KMadan
Posts: 1,074
Registered: ‎05-27-2009
Message 4 of 4 (218 Views)

Re: Sitescope monitor state after a Performance Center 11 test run

It may be a defect, contact hp with relevant logs.


Madan
Please use plain text.
The opinions expressed above are the personal opinions of the authors, not of HP. By using this site, you accept the Terms of Use and Rules of Participation