10-29-2012 10:08 AM - edited 10-29-2012 11:10 AM
The Distribution is
Script_A : 60 Users
Script_B: 35 Users
Script_C: 5 Users
Test Design should be as below:
a)Start Script_A & Script_B together ->Go Up to 40 Users Script_A & 20 Script_B,
and after ramp up of 60 users hold the test for 15 minutes.
b)Start Script_C-> 5 users ->Hold it for 15 minutes
c)Start adding 20 users for Script_A and 15 Users for Script_B -> Hold it for 10 minutes
Scenario Schedule designed by selecting the Group & distributed the users among 2 scripts.
1.I don’t know how to hold the test for 15 min’s t Script_A & Script_B together once, they started?Because as soon as scripts are in ready state and the next state is Run state.I am n't sure how to pause for 15 min's after Rampup ?
Did I understood correctly?Correct me, If I am wrong.
2.I can add more users for Script_A & Script_B by selecting the Vusers->Add Vusers under the Run tab. Is it Correct?
Please please advise me!
11-02-2012 12:00 PM
Please refer attached document.
I am not sure if this helps, I tried to understand your situation.
Apart from attached document, I think controller or PC has capability of having execution in paused state for different groups in scenario.
I hope this helps. If yes accept the solution.
10-30-2013 08:33 AM
I want to know couple of things :
1) Say I have to run a Scalability Test (1x, 2x, 3x etc.). Now the test is ramping up from 1x to 2x. During the ramp-up I want to stop the ramp-up & want the test to be running with the current load (whatever it gained till that time).
What could be my option?
2) Assume I hold on the ramp-up & test is running with the current load. Now after 10 minutes again I want the test to ramp-up from where it was stopped.
Is it possible? Or once I pause the ramp-up, the test will go on till completion with the current load only?