HP 8460p - Mobile Broadband Hardware Radio Status (857 Views)
Posts: 1
Registered: ‎05-21-2012
Message 1 of 1 (857 Views)

HP 8460p - Mobile Broadband Hardware Radio Status



we' re facing a problem with the HP Mobile Broadband device (un2340) on our HP 8460p. If you DON'T install the HP Connection Manager you are unable to change the hardware radio state. Once the hardware radio state is enabled by the ConManager you can deinstall the HP ConManager. A third party software can access the hardware and will also find a networkpovider.  With out changing the hardware radiostate a providernetwork will be not found, which sounds logical, or ?


To check the hardwarestate you can use netsh mbn show radio="Interfacename". The button on the 8460p will not change anything on the radiostate.


So how can I enable the hardware radiostate to "ON" without installing the ConManger ? Maybe with a switch while installing the driver. We are using WDS.


Regards Timo

The opinions expressed above are the personal opinions of the authors, not of HP. By using this site, you accept the Terms of Use and Rules of Participation.