05-08-2013 01:07 AM
Recently we purchased several HP Elitepad 900 tablets. Now we want to install our corporate image from WDS through PXE boot on those tablets. We have a Windows Server 2008 environment with WDS and MDT 2012 (6.0.2223.0). When i try to network boot (F12) in a docking station the system says "START PXE over IPv4, press ESC to exit" and then "network not found". So i can't PXE boot. I have read several posts and articles about elitepad 900 and pxe boot and the main suggestions have been that you should have MDT 2012 update 1, WinPE 4.0 and Server 2012. Do i really need those prerequisites or is there a another way of how to get elitepad 900 and pxe boot working together ?
05-08-2013 09:26 AM
The Elitepad can only PXE boot from EFI, so you PXE boot server must be EFI aware, unfortunately server 2008 R2 is NOT. You'll need to install windows server 2012, add WDS, then you'll see in the WDS properties you'll be able to specify what boot.wim files to use for x86, x64, AND x64EFI X86 EFI.
Also note that the elitepad can only boot from X86 bootable images, pxe or USB disks.
I hope this helps.
05-08-2013 11:28 AM
Eexactly. Microsoft added UEFI x86 PXE support to WDS under Windows Server 2012, and that is a requirement. You also need to make sure that, although you are using MDT 2012 (yeaayyy), you also use Microsoft ADK (which is WinPE 4.0 based), instead of the WAIK tools (based on WinPE 3.1)
HP produced a quick document that shows how to properly reimage an ElitePad 900 G1 and is posted on the web at http://h20000.www2.hp.com/bizsupport/TechSupport/C
Please, follow up if you have additional questions
11-25-2013 09:30 AM
I am having this same issue however before I get into details thanks for starting me on the right track with troubleshooting this. EFI is new to me, I've used WDS and Sysprep for everthing in the past. I have deployed a 2012 Server and using the Elitpad with Windows 8.1. I know nothing of MDT and have just installed in and started trying to teach myself. However please tell me there is an easier way to capture and deploy these tablets? My tablet will attempt PXE and I do get a quick message tellign me station IP address, however it then goes right to "Network Not Found". What does MDT and WDS have to do with each other?
I followed the HP article on this but that was little to know use as their instructions assume to much and leave so much detail out. Am I creating the image in MDT and moving it to WDS. All I want to do is get this tablet to pxe boot. Basically they are a bunch of paper weights if cannot image them with our software. Any help or info would be greatly apprecaited!
11-25-2013 10:23 AM