Re: OpenVMS and TCPIP Printing (334 Views)
Reply
Occasional Visitor
SeanBoston
Posts: 2
Registered: ‎09-13-2011
Message 1 of 5 (385 Views)

OpenVMS and TCPIP Printing

Hello All;

 

Recently we've upgraded our print queues from Multinet stream queues to TCPIP print queues. Since the upgrade we have issues where queues are stalling all the time. It only appears to be affecting printers that are connected to Cisco Access Servers 2500 routers and ports 4000 and above.

 

Any one have any experience with the same issue?

 

Regards,

 

Honored Contributor
Hoff
Posts: 4,964
Registered: ‎01-29-2006
Message 2 of 5 (377 Views)

Re: OpenVMS and TCPIP Printing

Checked the logs for the print symbiont(s)?

 

How many printers?

 

Your reference to Cisco Access Server 2500 implies remote-connected printers and possibly dial-up connections, and that set-up can add a whole big pile of transient weird into any network configuration, with a side-helping of both flaky and unreliable.

 

The default IP port for printing on a whole pile of printers is 9100, so seeing printer ports active above 4000 is entirely normal.

 

Verify the network switch configurations and accessibility of the devices; transients and configuration errors can trigger these sorts of errors, too.

 

Trusted Contributor
Jeremy Begg
Posts: 383
Registered: ‎01-20-2005
Message 3 of 5 (371 Views)

Re: OpenVMS and TCPIP Printing

You said, "Recently we've upgraded our print queues from Multinet stream queues to TCPIP print queues...", so you've removed MultiNet TCP/IP from your system and installed TCP/IP Services instead?

 

What printer symbiont are the queues using?

 

If possible, run tcpdump on the print traffic to see when the stall occurs.

 

Regards,

Jeremy Begg

 

Occasional Visitor
SeanBoston
Posts: 2
Registered: ‎09-13-2011
Message 4 of 5 (346 Views)

Re: OpenVMS and TCPIP Printing

We are using TCPIP$TELNETSYM symbiont. Sorry we migrated from Alpha servers running OpenVMS and Multinet to Itaniums running OpenVMS and TCPIP services.

Trusted Contributor
Jeremy Begg
Posts: 383
Registered: ‎01-20-2005
Message 5 of 5 (334 Views)

Re: OpenVMS and TCPIP Printing

There are a whole lot of logical names for controlling the TCPIP$TELNETSYM symbiont, I think many of them are documented in the TCP/IP Services Management Guide (chapter 25 I think).

 

I find SYS$SYSTEM:TCPIP$TCPDUMP.EXE to be very handy in solving these sorts of problems.  (It's almost identical to the MULTINET TCPDUMP program you might have used previously.)

 

Regards,
Jeremy Begg

The opinions expressed above are the personal opinions of the authors, not of HP. By using this site, you accept the Terms of Use and Rules of Participation.