Re: Open VMS Alpha OS Versio 7.2 (240 Views)
Reply
Occasional Contributor
ie000143
Posts: 10
Registered: ‎03-14-2006
Message 1 of 3 (332 Views)

Open VMS Alpha OS Versio 7.2

[ Edited ]

Open VMS and SNMP
I need to change the default SNMP configuration  to have no private or public strings and I do not know the command line sequence to do this.

 

 

P.S. this thread has been moevd from Community Feedback & Suggestions to OpenVMS > Networking. - HP Forum Moderator

Honored Contributor
Steven Schweda
Posts: 9,096
Registered: ‎02-23-2005
Message 2 of 3 (316 Views)

Re: Open VMS Alpha OS Versio 7.2

Trusted Contributor
Peter Zeiszler
Posts: 354
Registered: ‎12-23-2003
Message 3 of 3 (240 Views)

Re: Open VMS Alpha OS Versio 7.2

If you have no private or public community strings, why have SNMP enabled?

 

What version of TCPIP are you running may be different for which files or locations the SNMP is located.  If you are using a different IP stack, then this won't even help any.

 

If you are on a newer version of TCPIP this should show what community strings you have setup:

tcpip show config snmp/full

type  SYS$SYSDEVICE:[TCPIP$SNMP]TCPIP$SNMP_CONF.DAT

 

If the strings are setup in the SYS$SYSDEVICE:[TCPIP$SNMP]TCPIP$SNMP_CONF.DAT file, then edit the file to remove them.

 

If the community strings are setup in the tcpip config, then you remove them via : tcpip set config snmp /nocommunity="name"

The opinions expressed above are the personal opinions of the authors, not of HP. By using this site, you accept the Terms of Use and Rules of Participation.