HP-UX 11i Version 3 - Commands for Network Administration. (561 Views)
Reply
Occasional Contributor
Grande_bart
Posts: 2
Registered: ‎03-20-2012
Message 1 of 3 (561 Views)

HP-UX 11i Version 3 - Commands for Network Administration.

Dear All,

 

I have two HP Blade bl860ci2 with cluster and teaming (Virtual IP). Each Balde have one Teaming IP (Virtual IP).

But, I don´t know the reason, one Blade lost the Teaming Conection (Virtual IP).

I need to know the commands in the HP-UX 11i Version 3 SO, how to do to Check The Teaming , How to change, How to Check, How to Test Teaming in the HP-UX 11i. Some Commands that can be useful.

 

Thank you very much.

 

Best Regard

 

GB.

Acclaimed Contributor
Torsten.
Posts: 23,442
Registered: ‎10-02-2001
Message 2 of 3 (559 Views)

Re: HP-UX 11i Version 3 - Commands for Network Administration.

You should use nwmgr, examples:

# nwmgr -v -c lan900

# nwmgr -S apa

# nwmgr -g -v -c lan0

etc.

Hope this helps!
Regards
Torsten.

__________________________________________________

There are only 10 types of people in the world -
those who understand binary, and those who don't.

__________________________________________________

No support by private messages. Please ask the forum!

If you feel this was helpful please click the KUDOS! thumb below!   
Esteemed Contributor
Modris Bremze
Posts: 337
Registered: ‎09-11-2009
Message 3 of 3 (532 Views)

Re: HP-UX 11i Version 3 - Commands for Network Administration.

lanscan [-v]

lanadmin

 

If you use HP Auto Port Aggregation, its documentation can be found here -> http://h20000.www2.hp.com/bizsupport/TechSupport/DocumentIndex.jsp...

 

The opinions expressed above are the personal opinions of the authors, not of HP. By using this site, you accept the Terms of Use and Rules of Participation.