Re: CentOS 5 & BL460C Flex 10 Nic Not working (518 Views)
Reply
Occasional Visitor
Govan
Posts: 1
Registered: ‎05-25-2011
Message 1 of 2 (518 Views)
Accepted Solution

CentOS 5 & BL460C Flex 10 Nic Not working

I recently installed a cent0s5 os package and during boot, the init complains that no eth0 was found. When i run ifconfig, only the loop back address is active. I installed all the rpms for the centos starter package but that made no difference. Im assuming its a driver issue?
Honored Contributor
rick jones
Posts: 3,814
Registered: ‎12-02-1996
Message 2 of 2 (518 Views)

Re: CentOS 5 & BL460C Flex 10 Nic Not working

Probably. There was a minimum RHEL5 "dot rev" required for the BL460c G6's with the Flex 10 LOM. You would, I presume require the corresponding dot rev of CentOS. You might try a web search on "ProLiant linux exception matrix" to find the pages that describe the minimum revs for the supported distros.
there is no rest for the wicked yet the virtuous have no pillows
The opinions expressed above are the personal opinions of the authors, not of HP. By using this site, you accept the Terms of Use and Rules of Participation.