pairwise configuration (157 Views)
Frequent Advisor
Posts: 119
Registered: ‎12-08-2011
Message 1 of 2 (157 Views)

pairwise configuration

Hello Experts,


I was trying to create a pairwise configuration for diskError and diskError Clear.


When the normal event reaches NNMi, it is closing both the incidents.


I tried to select the "Delete when cancelled"  and interval of 15 sec.


when i invoked the trap by nnmsnmpnotify still i am seeing 2 events in the console.


Is there any way to delete the normal  event  and move the critical event to closed state ??


NNMi9.23 running on windows



Trusted Contributor
Posts: 115
Registered: ‎03-13-2014
Message 2 of 2 (127 Views)

Re: pairwise configuration

Hello Tanish,


The following docs could be helped with the pairwise configuration, kindly see it:

Note: You can configure NNMi to delete traps when they are canceled/closed. (By check box: Delete When Canceled).

The deleting of events from the pairwise operation is done by another theard that runs every 2 minutes, so you might first see the traps in the browser >> and then you might see them close and get deleted.

Hope this help!

Best Regards,
HP Support
IF this or any post resolves your issue, Plz be sure to mark it as an accepted solution.
To show your appreciation, click KUDOS !!!
The opinions expressed above are the personal opinions of the authors, not of HP. By using this site, you accept the Terms of Use and Rules of Participation.