Spiral Discovery configuration (313 Views)
Reply
Honored Contributor
ramesh9
Posts: 1,121
Registered: ‎04-19-2011
Message 1 of 2 (313 Views)

Spiral Discovery configuration

Hi All

 

How to configure Spiral Discovery in NNM 9i

 

Also is it required to configure a single seed for Spiral discovery to work or does spiral discovery works based on IP ranges without Seeds.

 

Please advise.

Respected Contributor
mostafa_hassan
Posts: 286
Registered: ‎12-11-2011
Message 2 of 2 (294 Views)

Re: Spiral Discovery configuration

Hello Ramesh , 

 

 

You have total control over which Nodes are discovered by configuring a Discovery Seed for each Node. To define a Discovery Seed, you provide one of the following sets of information:

  • hostname ( not case-sensitive) and Tenant
  • IP address and Tenant

NNMi uses the Discovery Seed to make initial contact. Discovery seeds are only relevant during initial discovery. NNMi requests each Node's current Management Address (the address from which the node's SNMP Agent responds) and uses that IP address for all communication after initial discovery. You can configure discovery seeds three ways,

 

Dynamic discovery process continues over time. When things change in your network
management domain, Spiral Discovery automatically updates information according to a schedule
that you set. The topology maps always reflect accurate and timely information about any changes
within your network.

 

 

 

please check in the attached document in Page 175 . 

 

 

All the best .
Saying Thanks by hitting Kudos :)

Regards
Mostafa Hassan
HP AIS NNM-NA-OO
CCNA-CCNP-ITIL-VCA-Cloud-VCA DataCenter
The opinions expressed above are the personal opinions of the authors, not of HP. By using this site, you accept the Terms of Use and Rules of Participation.