SNMP Agent Not responding on Node (739 Views)
Reply
Frequent Advisor
Nithyaraj
Posts: 65
Registered: ‎09-11-2013
Message 1 of 4 (739 Views)

SNMP Agent Not responding on Node

Dear Expert,

 

We have receviced the minor alert ie. SNMP Agent Not responding  on node

 

On that node Interface status is unknown

And alse we have checked the snmpwalk the output is

 

C:\Users\hpoveuser>nnmsnmpwalk.ovpl CDB_RACK3_SANSW
No response from CDB_RACK3_SANSW, verify credentials.

 

 

Thanks in advance

E.Nithyaraj.

 

Thanks& Regards
E.Nithyaraj.
If you can dream it, you can do it......
Frequent Advisor
tanish
Posts: 119
Registered: ‎12-08-2011
Message 2 of 4 (722 Views)

Re: SNMP Agent Not responding on Node

hello Nithyaraj,

 

nnmsnmpwalk.ovpl -c <community string> CDB_RACK3_SANSW

 

community string you can check in the snmp settings of the node CDB_RACK3_SANSW.

 

also make sure the nnm servers are in the mentioend in the acl

Frequent Advisor
Nithyaraj
Posts: 65
Registered: ‎09-11-2013
Message 3 of 4 (716 Views)

Re: SNMP Agent Not responding on Node

Hi Expert,

 

 

I have  checked  with nnmsnmpwalk -c community string  CDB_RACK4_SANSW

 

Even i geting same output only....

 

 

 

Thanks & Regards

E.Nithyaraj

 

 

Thanks& Regards
E.Nithyaraj.
If you can dream it, you can do it......
Frequent Advisor
Swarnm
Posts: 52
Registered: ‎06-10-2012
Message 4 of 4 (710 Views)

Re: SNMP Agent Not responding on Node

[ Edited ]

Hi,

 

it is SNMP issue at Node end, Check community string and destination IP at Node end(SNMP Setting)..

If device have SNMP Version 3 Capability,Also verify credentials

 

Swarnm......................................................
..................always say 'YES' with heart...!!!
The opinions expressed above are the personal opinions of the authors, not of HP. By using this site, you accept the Terms of Use and Rules of Participation.