Registered incidents in NNMi (151 Views)
Reply
Frequent Advisor
tanish
Posts: 119
Registered: ‎12-08-2011
Message 1 of 2 (151 Views)

Registered incidents in NNMi

[ Edited ]

Hello Experts,

 

Is there any mechanism in NNMi to clear the Registered incidents in NNMi ? In other words is there any retention period for incidents in NNMi ?

 

There are many traps, for which i dont have a clearing event. Just wanted to do a clean up.

 

NNMi 9.23 running on windows

 

Thanks

Anish

Trusted Contributor
trinhdong
Posts: 115
Registered: ‎03-13-2014
Message 2 of 2 (137 Views)

Re: Registered incidents in NNMi

Hello Anish,

 

The incidents generated in NNMi console will not get cleared/ reduced automatically until it's incidents has been reduced from the database by using nnmtrimincidents.ovpl.

You should use the command: “nnmtrimincidents.ovpl -trimOldest 20000” to trim the oldest incidents. You can repeat the command as many times as needed. Once its incident get removed from database, it will clear in Incident Browsing immediately.

 

You can find the syntax of the nnmtrimincidents.ovpl in the following docs

 

support.openview.hp.com/selfsolve/document/KM1306973/binary/nnmi_reference_pages_9.1x_p3.pdf

 

Thanks a lot and hope this help.!

Best Regards,
Dong
HP Support
IF this or any post resolves your issue, Plz be sure to mark it as an accepted solution.
To show your appreciation, click KUDOS !!!
The opinions expressed above are the personal opinions of the authors, not of HP. By using this site, you accept the Terms of Use and Rules of Participation.