NNM map color customization (217 Views)
Reply
Occasional Advisor
nojha159
Posts: 15
Registered: ‎06-08-2011
Message 1 of 4 (217 Views)

NNM map color customization

Hi,

 

I am using NNM 9.10 on windows.

My problem is that if any interface on any specific router goes down then its not changes

the color of the whole router and we are not able to find the change in network on seeing the map.

It changes the color of router when the whole router goes down,not a single interface.

 

Now by any customization is it possible to change the color of router when any of it's interface goes down.

 

Please anyone reply.

 

Thanks in advance.

 

Regards

N.ojha

nikhil
Regular Advisor
Navarath
Posts: 88
Registered: ‎06-27-2011
Message 2 of 4 (213 Views)

Re: NNM map color customization

If you are expecting node status propagation........then this may help you

To configure Node Group status calculations, do the following:
1. Navigate to the Status Configuration form.
a. From the workspace navigation panel, select the Configuration workspace.
b. Select Status Configuration.
2. Make one of the following configuration choices:
n To assign the Node Group the most severe Status of any Node Group member, in the Status
Configuration form, under Global Control, make sure Propagate Most Severe Status is
checked:
Propagate Most Severe Status
n To configure percentage values for a Node Group Target Status, do the following:
n In the Status Configuration form, under Global Control, make sure the Propagate Most
Severe Status is cleared:
Propagate Most Severe Status
n Configure the percentage values for a Node Group Target Status
3. Click Save and Close.
NNMi applies your changes after the configuration is saved.

Good Luck!!!
Occasional Advisor
nojha159
Posts: 15
Registered: ‎06-08-2011
Message 3 of 4 (212 Views)

Re: NNM map color customization

Thanks a lot.

will apply and revert you soon the result

Thanks
nikhil
Honored Contributor
Ian_4
Posts: 3,738
Registered: ‎10-04-2000
Message 4 of 4 (196 Views)

Re: NNM map color customization

That is not possible in NNMi, you need an enhancement.  Hope this helps.  

The opinions expressed above are the personal opinions of the authors, not of HP. By using this site, you accept the Terms of Use and Rules of Participation.