Re: Modifying source node and source object of NNM incident (306 Views)
Reply
Honored Contributor
Posts: 1,423
Registered: ‎04-19-2011
Message 1 of 3 (375 Views)

Modifying source node and source object of NNM incident

9.11 on HP UX

 

Is it possible to modify Source node and Source Object of NNM incident using enrichment or any other means?

 

Please advise.

HP Expert
Posts: 752
Registered: ‎03-13-2012
Message 2 of 3 (324 Views)

Re: Modifying source node and source object of NNM incident

Hello Ramesh

 

 

This thread is  already answered in the following  URL

 

http://h30499.www3.hp.com/t5/Network-Node-Manager-Support/Modifying-Source-Node-and-Source-Object-of...

 

 

Hope this information was helpful!

 

Please visit our new customer forum if you have a valid SAID  support contract at the following link.

http://h30499.www3.hp.com/t5/Network-Node-Manager-Support/bd-p/network-node-mgr-support-cust-forum#....



HP Support

The views expressed in my contributions are my own and do not necessarily reflect the views and strategy of HP

If you find this or any post resolves your issue, please be sure to mark it as an accepted solution,If you are satisfied with anyone’s response please remember to give them a KUDOS and show your appreciation.

Highlighted
Trusted Contributor
Posts: 178
Registered: ‎06-13-2006
Message 3 of 3 (306 Views)

Re: Modifying source node and source object of NNM incident

Hi Fariassolis,

 

the linked thread just points to the information that there has been a support call on this issue.

But, there is no solution given.

 

I'm interested in the answer, too.

So, please share your suggestions.

 

Thank you

Alexander

The opinions expressed above are the personal opinions of the authors, not of HP. By using this site, you accept the Terms of Use and Rules of Participation.