DNS resolution for Nodes not in DB but sending traps (183 Views)
Occasional Contributor
Posts: 5
Registered: ‎04-25-2012
Message 1 of 2 (183 Views)

DNS resolution for Nodes not in DB but sending traps

Hello All,


I have a NNMi 9.22 in place and want to send traps from devices not in the NNMi DB.

NNMi processes the trap in nnmtrapdump.ovpl and displays the DNS resolution for the IP of the sender, for instance src. ip is and this is resolved by the DNS is host1.com.
But if it comes to the NNMi GUI in the workspace Incident Browsing I cannot see the translation, it is only the IP.

Where can I configure the translation from IP to FQDN even if the device is not in the NNMi DB.


HP Expert
Posts: 752
Registered: ‎03-13-2012
Message 2 of 2 (147 Views)

Re: DNS resolution for Nodes not in DB but sending traps

Hello Patrick


This was an enhancement request submited




I invite you to the new customer support forum if you have a vaild  support contract SAID. you can visit is in the following link





HP Support

The views expressed in my contributions are my own and do not necessarily reflect the views and strategy of HP

If you find this or any post resolves your issue, please be sure to mark it as an accepted solution,If you are satisfied with anyone’s response please remember to give them a KUDOS and show your appreciation.

The opinions expressed above are the personal opinions of the authors, not of HP. By using this site, you accept the Terms of Use and Rules of Participation.