11-09-2012 12:51 AM
Do any one have idea of this error?
While I am using the command loadhosts to add the following topology, the command the following error.
Adding Topology of swx03ntcs(10.49.3.210)...
1) Created swx03ntcs (id = 789938)
1) Added 10.49.3.210 (id = 789939) to swx03ntcs
ERROR: Could not add node swx03ntcs to topology: Requested object is unknown
Adding Topology of swx03ntcs(10.49.3.210) - FAILED!!!
The node can snmpwalk and nslookup normally. We are using NNM 7.53 and OMU 8.35.202. Thanks.
Solved! Go to Solution.
11-09-2012 03:59 AM
Please, check out the KCS doco http://support.openview.hp.com/selfsolve/document/
You need to supply correct mask with loadhosts command. Like:
loadhosts -v -m <netmask> -c <IP address> -n 1
And also netmon should be stopped before you use loadhosts. So, preferred is using "netmon -h <IP>" if you run NNM 7.53.
To make use of this command, netmon auto-discovery has to be tuned on.
If you find that this or any post resolves your issue, please be sure to mark it as an accepted solution.