02-13-2007 09:43 AM
02-15-2007 12:35 AM
you are meaning that windows, during the installation process, qhen you pess F6, doesn't read the driver from the floppy?
and, after that, windows is not able to find out the HDs in RAID and install itself over them?
let me know.
02-15-2007 06:41 AM
"Setup was unable to load support for the mass storage device you specified. Currectly, Setup will load support for the following mass storage device(s):
* To specify additional SCSI adapters, CD-ROM drives, or special disk controllers for the use with Windows.including those for which you have a device support disk from a mass storage device manufacturer, press S.
* If you do not have any device support disks from a mass storage device manufacturer, or do not want to specify additional mass storage devices for the use with Windows, press ENTER."
When I do press "S" and try and run the RAID Controller of a floppy disk, it is unable to do so. What should I do??
02-18-2007 08:04 AM
windows, at the second start, during installation, sisable the USB ports.
are you using an HP USB floppy?
let me know.
the problem will be solved ...
02-18-2007 08:29 AM
02-18-2007 08:37 AM
...may be You can find the solution for a few "assigned points" to the answers...
try to do this:
connect to the site
download the "installer".
run the installer.
follow the instructions.
so, you can create your own bootable CD containing all the driver you need.
after that, you can try to install windows usig that cd.
yuo don't have to press "F6"...
all the driver windows need will be on the CD you created.
let me know...
02-18-2007 09:06 AM
only remember to prepare the correct driver to "pass" to the installer when you prompted.
good luck and good night.
in Italy it's quite late ...
I'll go to sleep.
tomorrow morning is Monday ... e new week of "had work" is beginning ...
05-13-2008 12:58 PM