12-27-2011 04:16 PM
I have a question about an HP Netserver LP1000r.
Does this server have an integrated RAID controller?
Or must be an PCI board attached on the system?
01-06-2012 12:52 AM - edited 01-06-2012 12:56 AM
The LP1000R does not have an integrated RAID controller built into the system board. If you need it, you will have to install a separate SCSI RAID controller into the one available PCI slot.
The NetServer LP 1000r has an embedded dual-channel Ultra 3 Wide PCI SCSI controller. It has 2 Channels. Channel A is used for cabling to the hot swap hard disk cage. Channel B is connected to an external port for external SCSI devices.
For adding an additional Disk Array Controller (NetRAID), as per the documents available, HP recommends only using the NetRAID “1Si “ (D2140A) PCI board in Netserver lp 1000r
Part number: D2140-69004
Description: NetRaid-1Si one-channel disk array controller - PCI board with one internal 68-pin High Density and one external 68-pin Ultra High Density SCSI connector.
However, the above part is currently not available in production.
****You may also refer below HP document for HP Netserver LP 1000r FAQ:
Hope the info will help you :)
Was this post useful? - You may click the KUDOS! thumb below to say thank you.